Make your own Halloween Tombstone using Direct Colors Inc. products in 11 Easy Steps! Happy Halloween!
Time Required: 3 Days
• Large Piece of Cardboard (The front of our cardboard tombstone is 25″ tall, 21″ wide and 3″ deep)
• Craft Knife
• Small Putty Knife
• 2 Metal Stakes – cut 6 inches taller than the full height of your tombstone project
• Small Foam Brush
• 3M Multipurpose Adhesive
Our tombstone is 25″ tall, 21″ wide and 3″ deep
Using a craft knife, cut your cardboard to desired specs. Make joints in the cardboard by scoring the topmost layer, leaving the rest of the cardboard intact. Bend cardboard away from the score line to create a clean joint.
Cut additional pieces of cardboard for supports. Score and bend the support pieces for clean joints.
Tape interior supports to the inside of your cardboard tombstone to maintain the shape of your box and support the weight of the concrete overlay. Once interior supports are in place, tape your concrete tombstone closed.
Design and draw accents onto spare pieces of cardboard.
Using a craft knife, carefully cut out the cardboard accents and attach to your tombstone with 3M Multipurpose Adhesive.
Define your concrete tombstone with a colorant such as Deco Gel Stain and Acetone-based Concrete Dye.
• We used Shifting Sand Deco Gel Stain and Concrete Dye in Charcoal and Ash Brown.
Seal your project again using Acrylic Satin Finish Sealer to protect the color.
*Note: Allow project to dry for at least 24 hours before proceeding.
We made cuts near each bottom corner of the tombstone so our stakes would support the project.
Cut 2 metal stakes roughly 6 inches taller than the height of the tombstone. You can use re-bar, metal conduits, etc. as stakes. We used metal electrical conduits for our stakes (they just happened to be on hand at the time)
Measure the location of the X cuts on the bottom of your project, make a mark in your yard where your stakes should be set, then drive the metal stakes into the ground using a pretty solid hammer
Carefully match up your X cuts on the bottom of your tombstone with the location of the grounded stakes.
Gently apply pressure so the stakes are completely inserted into the tombstone and the tombstone touches the ground